Need measurement for tranny

[superjeep]

I need the measurement on a cj with a model 300 transfercase.

what is the measurement to the center of the rear driveshaft ?

mine is 26" inside width of frame and it is at about 11" from drivers side.
I am trying to see if it should be directly centerd or if it is off set a few inchs.

thank you.
Shawn

[carwash]

All the trannies i know measure at least 5'10" or taller... most with a size 12 heel as well.... wanna see some pics?

hahahhah, sorry shawn, but the thread title made me giggle...

I have no tech to offer, i'm retarded.

[superjeep]

Yes I guess I should of used the full name off what I am looking for. But I am
just falling into the lazy ass typing ebonics.

Shawn

[carwash]

I do have a dana300 if you need one...

[JET455]

All the trannies i know measure at least 5'10" or taller... most with a size 12 heel as well.... wanna see some pics?

hahahhah, sorry shawn, but the thread title made me giggle...

I have no tech to offer, i'm retarded.


You just love to get your high heels out don't you........:eek:

[carwash]

only when i know yer coming down to the house... special occasions only.

[JET455]

only when i know yer coming down to the house... special occasions only.


You have to pay for your parts somehow...........;)

[BiggDaddy]

I have a cj with a 258, chrysler auto transmission, and dana 300. At the output of the transfer case, I measure 32" inside the frame rails. From driver side inside frame is 15" and from passenger side inside frame is 17". It's offset just a bit to match the amc 20 rear axle. Hope this helps.

BiggDaddy