tire sidewall repairs

[NKYJEEPSTER]

Anyone know a place around Cincy that can fix a hole in the sidewall of a tire? I got a pin head size hole in a tire looking to get it repaired.

[pitracer1]

there is a place in milford, its on meijer drive. off hand cant think of the name but its on the left hand side.

[kb9qdi]

Most shops won't repair a sidewall due to saftey but......some will, mainly independent shops. Options.....

Tube it, cheap but I personally wouldn't run on it everyday. Good for a spare in my eyes only or for a trail rig.

Try and pull thru patch plug....may/may not work.

Find a shop that vulcanizes sidewalls. Can be Pricey but usually works well,again I still wouldn't trust itfor a DD. I repair/sell tires for a living and have tried sidewall repairs for many fellow off roaders and most hold for awhile but usually fail over due time. If it's a tire your going to depend on every day I'd replace it and be done with it. Trail rig, I'd try the repair or use it for a spare. If it fails your not running 70 mph on the express way risking yours and everyone's life.

Some will say go for it no mater but I wouldn't on a DD. I see them fail everyday from sidewall flex and heat buildup. Usually when a tire runs low on air the sidewall heats up and the rubber gets soft/fails damaging the tire and or the sidewall making it unrepairable anyway.

Good Luck

[underpowered]

Pull through patch plug is what i have always had luck with on a sidewall.

as the above said, i would not DD a patched sidewall tire, must more prone to failing than a typical tread patch. use it as a spare if it is on a driver.

[fabricator]

http://www.cincyoffroad.com/forum/showthread.php?t=2774&highlight=tire+repair

[jlynch]

I have had 2 sidewalls repaired at Bob Sumerel tire in Dayton Ohio. They are used for offroad only but they are still holding air just fine. If you have a bias ply tire it will be easily fixable. One of my tires was a radial, they was able to fix it but it looks like ****. Price is reasonable also, hell of a lot cheaper than a new tire. Here is the address.


Bob Sumerel Tire
7711 Center Point 70 Blvd.
Dayton, OH 45424
Phone: (937) 235-0062
Fax: (937) 235-0064

[tjjeepjeep]

For those I've asked about this topic, I found the thread. Will call tomorrow to ask. I'll probably call the Milford one..though now I wonder if Dayton is closer to me. hmm

Best One Tire of Mid America Service manager Pete Waits 513-248-3900.

[KennyTJ]

I had a nearly new IROC with a sidewall cut repaired in Milford at Best One, and it looks NEW! No problems, it is a bias tire, not sure if that makes a difference. They do the sidewall repair at the retread/recap shop.

I have had no problems, saved a $300 tire!

[tinbeater]

For those I've asked about this topic, I found the thread. Will call tomorrow to ask. I'll probably call the Milford one..though now I wonder if Dayton is closer to me. hmm

Best One Tire of Mid America Service manager Pete Waits 513-248-3900.

If you go to Milford ask for Steve blankenship

[tjjeepjeep]

Now to see how a 35 fits in the trunk of an x90


giggle

[Hope Springs Hauler]

Now to see how a 35 fits in the trunk of an x90


giggle

Passenger seat.....The conversation would be as good as a mannequin:evilgrin:


(sorry....Had to say it)

[GPER]

I had a side wall patched on my Camry at Detroit tire in Xenia, its not far from Dayton. They would be closer than Center Point 70 if that is what I'm thinking is almost to New Carlisle.

[tjjeepjeep]

Got my tire back...Great people at Best One in Milford.

[biggin69]

Lisa, do you have any before and after pics of the repair? I have a nasty sidewall cut that I need repaired myslf. Nice junk in the trunk by the way!:thumbup:

[tjjeepjeep]

Didn't think to take any actually. I dealt with Ryan Bridley, Service/Fleet Manager, at 248-3900. Wish I'd have had time to do the tour of the repair facility..that'd been interesting.

[biggin69]

Didn't think to take any actually. I dealt with Ryan Bridley, Service/Fleet Manager, at 248-3900. Wish I'd have had time to do the tour of the repair facility..that'd been interesting.

Thanks Lisa! I will give them a call tomorow.:beers:

[carwash]

Maybe I missed it, but what did these shops charge you all for your repairs?

[tjjeepjeep]

vulcanizing (not sure on spelling) my sidewall was something like $40

and I still want to go tour it to see how the heck they do that

[Hope Springs Hauler]

vulcanizing (not sure on spelling) my sidewall was something like $40

and I still want to go tour it to see how the heck they do that

If you go at the right time, you might even get supper out of it:eek::p

[itbrokeagain]

Time to dig up an old thread. Cut a side wall and took it to best one. They didn't really want anything to do with it but said they would try. We will see.

[jwend]

Puckett at Shotgun does them.. a damn good job too

[biggin69]

Time to dig up an old thread. Cut a side wall and took it to best one. They didn't really want anything to do with it but said they would try. We will see.

Good luck. They told me the same thing on a tire I had. I told them it was an offroad only tire and if they could not fix, atleast they tried. They did not touch the tire.

[Jonesy]

Puckett at Shotgun does them.. a damn good job too

Got any contact info for Puckett? Slit one of the tractor tires on the yota. Tried patching it and didn't hold up.

[itbrokeagain]

Got any contact info for Puckett? Slit one of the tractor tires on the yota. Tried patching it and didn't hold up.

I'm interested also of this doesn't work out

[Drivermod]

Todds # at Shotgun Fab is 567-1117. In Verona right off 42 at the Boone/Gallatin Co. line.

[JeffK5]

Todds # at Shotgun Fab is 567-1117. In Verona right off 42 at the Boone/Gallatin Co. line.

He can hot vulcanize a tire ?..

[Drivermod]

He can hot vulcanize a tire ?..

Yep. As far as I know he has never had a return and I've seen him repair some nasty cuts. One was as long as a dollar bill and started in the bead. It wasn't a cheap repair but when your paying $400+ dollar's/tire sometimes it's just worth it.

[itbrokeagain]

Took my tire to best one in Milford on Tuesday. Their Customer service is horrible. I still have not heard if they can fix It or not. Every time I call, they say they have to call the retread shop and they will call me back. They never call me back. Then when I call again I get the same line. Getting a little frustrated.

[tjjeepjeep]

Took my tire to best one in Milford on Tuesday. Their Customer service is horrible. I still have not heard if they can fix It or not. Every time I call, they say they have to call the retread shop and they will call me back. They never call me back. Then when I call again I get the same line. Getting a little frustrated.

Wow must have changed since I had mine in there. I went to the Fleet Manager and not through the customer service line. Sorry to hear...

[itbrokeagain]

Called today. First thing he said was sorry I dropped the ball on this one they're working on it right now. They can fix it that's all I care about.

[tjjeepjeep]

Called today. First thing he said was sorry I dropped the ball on this one they're working on it right now. They can fix it that's all I care about.

That's good anyway..

[WrenchMonkey]

They can fix it that's all I care about.

Outstanding!

You know how much I like waiting for tires...

[itbrokeagain]

Find another place to fix your tires. Still waiting. I'm glad I was able to find another set for a good price. I dropped it off on November sixth as of today they have no idea what's going on with it

[biggin69]

Find another place to fix your tires. Still waiting. I'm glad I was able to find another set for a good price. I dropped it off on November sixth as of today they have no idea what's going on with it

That sucks!

[Jonesy]

I had Todd Puckett from Shotgun fab in Verona do mine. Took him less than a week and that was with thanksgiving in the middle. Only charged $85 to do one fairly large sidewall and a small slit in the tread face. He also guarantees his work to hold. Two thumbs up from me.

[itbrokeagain]

I had Todd Puckett from Shotgun fab in Verona do mine. Took him less than a week and that was with thanksgiving in the middle. Only charged $85 to do one fairly large sidewall and a small slit in the tread face. He also guarantees his work to hold. Two thumbs up from me.

I'm going to try to get it back and see what he can do