removal of the side gear bearing inside the 3rd of yota

[67fastback]

ok having an issue pulling the race bearing off the side of the pig, what are you guys using to pull it off, pitman pull is too small, 3 way jaws pull does not line up right... help!!

[67fastback]

looks like i found the tool but no one seems to care it instock
otc1028 diff bearing puller...:rolleyes::(

[pfreer3]

I can't understand what you are looking at. Bearing on the side of the pig would be a carrier bearing, and those don't get pulled on a yota. Just loosen the bolts on top and back out the retainer

read this site over
http://www.gearinstalls.com/

[Flxratd]

if you are trying to change carrier bearings what is easiest is to remove the bearing cage and roller bearings to access the bearing race(the cage can be cut with a nice set of side cutters) then carefully use a cut off wheel to grind at an angle across the surface of the race and get a good groove into it without hitting the housing then take a chisel and a hammer and strike in the groove you made which will crack the race in the groove and then will slide right off. wear eye protection and use a rag of sorts to cover the carrier while your doing this just to keep any crud out.

[humpy]

A bearing splitter and a press works pretty good too

[Flxratd]

A bearing splitter and a press works pretty good too

boo you just didnt want to type a novel like i did :thumbup:

[humpy]

Lmao

[67fastback]

well the reason for taken off the bearings cus I was goign to reuse them on the detoit locker that I was installing, but after I looked it closer i found that th detroit i bought was for a 61b V6 detroit and the bearing are larger I.D. than the 4cyc pig bearings so i can not use them.
I went to different auto stores adn they are pretty much useless to find the right part..
I emailed a few sites and found that Trail gear has what I need to put the v6 detroit in the 4 cyc pig (abr Locker bearings). I order the new bearings and will get next week, not find a some one to press them on when i get them...:eek:

hope to get this axle back under the sami before Harlin ride in 4 weeks..:thumbup: