View Full Version : where to get driveshafts made?
nickhuts
05-07-2012, 07:14 PM
Cincy Driveline? where have you guys had luck? I am in the market to get one made and one stretched out :thumbup:
jwend
05-07-2012, 09:57 PM
the guys at cincy drive line are awesome. tom woods drive shafts are not prices bad at all either for what you get
kirbyiv
05-07-2012, 10:04 PM
give Tom at Carolina Driveline a call. Not local, but his prices on driveshafts are still less than getting one local even after shipping. Tell him Kirby sent you and he will knock off a few bucks. 866-742-3848
coachholland
05-08-2012, 09:04 AM
I run Tatton's front and rear. He's just down the road from Tom Woods, equal in quality but a bit less expensive. 801-685-0056 Same deal as Kirby... if you tell him Chris from JeepAddOns sent you he may give you a bit of a discount.
johnb1686
05-08-2012, 11:58 AM
X2 on the Carolina i have one of his. Drivetrain specialist in west chester is pretty good on price also if you want local
nickhuts
05-09-2012, 07:59 AM
cool. thanks guys.
93 Krawler
05-09-2012, 11:12 AM
I had Cincy driveline make me a front shaft for my rig. I told him I used it for rock crawling, and to make it strong. I also told him I needed a lot of slip in the shaft, and a cv joint.
They used that thin tube, which I destroyed, and a wimpy cv, that's destroyed, and the female end of the spline is only about 2" deep, so my shaft wobbles real bad. Personally, if you want a tough shaft, don't go there. I have better luck buying my own parts and doing them myself. They aren't balanced, but I don't drive it on the street.
nickhuts
05-09-2012, 11:22 AM
I had Cincy driveline make me a front shaft for my rig. I told him I used it for rock crawling, and to make it strong. I also told him I needed a lot of slip in the shaft, and a cv joint.
They used that thin tube, which I destroyed, and a wimpy cv, that's destroyed, and the female end of the spline is only about 2" deep, so my shaft wobbles real bad. Personally, if you want a tough shaft, don't go there. I have better luck buying my own parts and doing them myself. They aren't balanced, but I don't drive it on the street.
Uh oh....don't tell me that! Just dropped them off yesterday....
93 Krawler
05-09-2012, 01:24 PM
uh oh....don't tell me that! Just dropped them off yesterday....
doh...
vBulletin® v3.8.11, Copyright ©2000-2024, vBulletin Solutions Inc.