FS/FT: FJ60 9.5" Toyota Axles
 

I've got a set of built toyota landcruiser axles for sale or trade.

Front:
TG Diff armor
Six Shooter Knuckles
Chromo Hubs
TG Upper and Front Truss
Trunion Bearing Eliminator Kit
TG Wiper Seals
New Wheel Bearings
ARP Hub Studs
ARP Knuckle Studs
Ruff Stuff's lancruiser to minitruck leaf swap kit
Ruff Stuff Shock Tabs
Fine Spline Pinion 4.11's with New Aussie Locker
30 Spline Longfields
Setup for Hydro Assist
Tie Rod is 1.25" DOM .25 wall threaded to accept Ruff Stuff Heims w/ misalignment spacers and safety washers
reinforced steering stops
knuckle ball gussets

Rear:
Recentered FJ60 Axle with minitruck shafts
Fine spline pinion 4.11's with New Aussier locker
New Bearings
Ruff Stuff Rear truss setup for 4 link
New Rotors
New Calipers

Will Trade for a set of Built Tons
Price: $1850 OBO
Located in Cincinnati, OH.

http://i1182.photobucket.com/albums/x449/burwinbg/4.jpg

http://i1182.photobucket.com/albums/x449/burwinbg/3.jpg

http://i1182.photobucket.com/albums/x449/burwinbg/2.jpg

http://i1182.photobucket.com/albums/x449/burwinbg/1.jpg

http://i1182.photobucket.com/albums/x449/burwinbg/5.jpg

Are you on IH8mud? You might get some interest on there... Those turned out to be some sweet axles...

Thanks for helping me out when I was first gettin started on them. I'm rebuilding again....and part of the rebuild is repowering, so I figured its time to pass these on and go to something a little stronger. I don't think there's a stronger Toyota axle available right now.

They would make a nasty set of axles for light weight buggy build! :thumbup:

what motor are you going with? I think you would be surprised how much abuse they can take...

Going with a 4.3 vortec on 39" red labels is the plan....with the intent to go to an LQ9 sometime way down the road. I have my th350, behemoth strong box 205 doubler going behind. My concern is with my 4k# curb weight and stickies.

Bump for $1750

Sold. Thank you