You Gotta Be Kidding Me!
 

After all the wheeling we did last weekend, not tearing up much but some sheet metal and a bumper. I stop by my friends house to show him how nice a locker is and bust a front axle CV:mad: How funny is that:eek: Oh well, a trip to the parts store and $80 later, I'm wheeling again:D

And ya'll make fun of me at Macy's

Don't feel bad ..... I switched out all my bent rims and shop vac'ed all the broken glass and then decided to run down the road to pick my son up from school ......... U-joint failure in front drive shaft at about 60 mph ..... took out fuel lines and most of my wiring harness fron trans back :mad: :mad: :mad: I"m ready to burn this thing

Now I really don't feel so bad!:D I hope it wasn't the u-joint we picked up off the ground with all the leaves and mud and stuff. Was it? :eek:

Just because we can:D

no it was the other end believe it ir not ..... just my luck !!!!

dam sarge sounds like you need another jeep, maybe your old zj

know how that goes. all the wheeling i did, and sheared the steering box off the frame in my driveway of all places.

I'm almost to that point Dan !

I'm really debating putting a set of Jeep axles under the Jimmy and keep it as a Mall queen and taking the 60's and starting over with a Jeep ...... SOOOOOOOOO much easier to work on !!!

if you decide to go that way the guy i sold the zj to is getting ready to sell

replace those CVs with u-joints!

Sounds like my luck Gary...I like running the CV'S too.Except the O-Reily's brand (They won't hold up to my abuse)I went two years running the stock spicers (From a ZJ) without blowing one.

Nick

OK. Cv's? Educate me.