Aisin hubs
 

Does anyone know how the springs on aisin hubs are supposed to go together?

That's a good question, I've fought one for hours before and couldn't figure it out.

Sent from my DROID RAZR using Tapatalk 2

See if this helps. http://www.4x4wire.com/toyota/mainte...d/hub_rebuild/

Nope:( haven't been able to find what I need

Put drive flanges on it and be done

That is what I will end up doing. I still want to figure out the hub though because my center diff doesn't unlock.

Your trying to hard, its simpler than it looks, spin the little spring into the groves of the flat metal piece, spin the other end into the outer hub gear, there is a slot on the outer hub( the part that you would turn to lock or unlock) place the big spring in between this. I hope this helps, any more info let me know, or if you want me to show you we can meet up somewhere n time this week and I can show ya. Jim

That would be good. All it is doing is making me angry.

Send me a Pm with times that are good for you Wed, Thur, or Fri.

i always have to put it together and take them apart 1 or 2 times before i get them right... :p

Appreciate that. I was able to put one of my flanges on. I think I will just bring it to the hangover run and see if someone there can figure it out. Thank you though.

If I make it to the hang over run I will put it together They are super easy to do. I just built a set and sold them. you can bring it up to the house in blanchester and I can built it

Plenty o pics on the link below....
http://forum.ih8mud.com/79-95-toyota...b-rebuild.html