Go Back   C.O.R.E. FORUM > Search Forums
Reload this Page Search Results
Gallery FAQ Community Calendar Today's Posts Search

Showing results 1 to 7 of 7
Search took 0.01 seconds. Search: Posts Made By: wilmesbm
Forum: General Discussions 03-13-2017, 09:27 PM
Replies: 12
Views: 7,077
Posted By wilmesbm
I will look through the rulebook tomorrow and see...

I will look through the rulebook tomorrow and see if it offers any insight.
Forum: General Discussions 03-13-2017, 08:53 PM
Replies: 12
Views: 7,077
Posted By wilmesbm
That's a good question and it is my understanding...

That's a good question and it is my understanding that you can weld chromoly to steel, but I'm not a 100% sure on that. I'm by no means an expert on that though so don't take that as fact.
Forum: General Discussions 03-13-2017, 08:16 PM
Replies: 12
Views: 7,077
Posted By wilmesbm
Asphalt, quarter and eighth mile depending on...

Asphalt, quarter and eighth mile depending on which track we're at. And dirt drags which are 300ft.

I daily drive an 11sec 2wd Dodge 1500 with a Cummins in it right now that I race as well, but...
Forum: General Discussions 03-13-2017, 08:13 PM
Replies: 12
Views: 7,077
Posted By wilmesbm
I'm not entirely sure what you're getting at with...

I'm not entirely sure what you're getting at with all the questions. It'll be competing in a 10.5 index class. It will remain 4wd. As I stated earlier, it will weigh in at approximately 5000lbs with...
Forum: General Discussions 03-13-2017, 08:04 PM
Replies: 12
Views: 7,077
Posted By wilmesbm
Tin Soldier was the shop I eluded to in my first...

Tin Soldier was the shop I eluded to in my first post. They were more than willing to weld in the pre-bent kit and said they had done so in the past, but are booked solid until the end of May....
Forum: General Discussions 03-13-2017, 07:54 PM
Replies: 12
Views: 7,077
Posted By wilmesbm
I sent him an email, thanks for the heads up.

I sent him an email, thanks for the heads up.
Forum: General Discussions 03-13-2017, 10:42 AM
Replies: 12
Views: 7,077
Posted By wilmesbm
Roll Cage Welding - Cincinnati Area

Ok, this is going to be a little out of the norm, but bare with me. I'm building a drag truck out of a 4x4 Dodge 2500 chassis and am in need of roll cage. I'm not really looking for something to be...
Showing results 1 to 7 of 7

 
Forum Jump

All times are GMT -4. The time now is 03:15 AM.

Contact Us - Cincinnati Off Road Enthusiasts - Archive - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 2021, C.O.R.E. All rights reserved.