|
OK!!! today was motor day. Bought my motor from a friend, a pull out from his jeep. Was a decent runner when he pulled it, but smoked a little at start up, so we decided it was the valve seals in need of some love. No big deal.
Well yesterday my buddy Bobb prepped and cleaned the motor and stripped it of all accessories, etc. And this morning, Brandon and I tore into it. Well we pop off the first valve, and there was no valve seal... we pop the other 7 off the one head, and not a valve seal on any valve. so, the valves were all disgusting and upon pulling them, none of them would seat and were all hung open... so off with the heads for a valve job. did it ourselves on the bench in about 2 hours. Ground them, reinstalled, light resurface, and slapped them back on. Cross your fingers.
Built up the tpi and stuck it on (no gaskets or anything, just stuck it all together with a few bolts), just to feel like i accomplished something the past 2 days. Got a few bars in the rear of the chassis as well... where is that new die, dammit. Here is a little picture recap of the weekend as well...
|