[carwash]

Driveshaft mockup and final install...

When you dont have straps, use duct tape. Black is made specifically for holding the u-joints into a yoke.



With the pillow block sitting directly on the mounting plate, i got an angle of almost 14 degrees, maybe even more than that with the upward tilt of the t-case front output.



What stinks about the whole thing is that i can't get more than 12" of drop out of the passenger side air shock right now before the yoke at the axle binds. Jess at High Angle says i can do a little massaging there, but not much. But with a center limit strap, that will help a little as well... may get up to 16" out of it, who knows... ugh.