Well, the copper CJ left the shop today... parting is such sweet sorrow. The cat will be upset that it lost its sleeping spot. Who knew a PRP seat would be such a great place to have kittens.
Anyway, was waiting for jim to finish his motor/trans/atlas install so i could build his crossmember/skidplate for it...
I went a little over the top i think... had to incorporate a mount for the tcase, a mount for the anti-wrap bar, and some protection for the trans pan. Here are some photos of the build process.
Started by putting the fabsets on the frame in the places i wanted them and working from there. Used bendTech to get my bends perfect, man i'ts an amazing piece of software once you get your dies calibrated to it...
tacked in the first tube, then pulled it to make the bosses for what would become the mount.
All tubing is 1.75 x .125, except for the bosses. They are 1.25 x .375 wall, which leave a perfect hole for a 1/2" bolt.
