C.O.R.E. FORUM - View Single Post - Pressing or beating AMC 20 axle bearing on

GPER · 02-12-2009, 02:40 PM

I was watching the Scout build link and at the end it showed what looked to be them beating the axle bearing on the 44 axle shaft with a piece of pipe.

Does the 44 bearing go on with less force then the AMC 20 bearing?????? I have been told beating a bearing on is a no no, but I have the bearing beater ready to go when I do mine.

Should I have it and the keeper ring pressed on or would you beat them on??????????

02-12-2009, 02:40 PM	#1
GPER Join Date: Feb 2007 Location: Kettering, Ohio Posts: 811	Pressing or beating AMC 20 axle bearing on I was watching the Scout build link and at the end it showed what looked to be them beating the axle bearing on the 44 axle shaft with a piece of pipe. Does the 44 bearing go on with less force then the AMC 20 bearing?????? I have been told beating a bearing on is a no no, but I have the bearing beater ready to go when I do mine. Should I have it and the keeper ring pressed on or would you beat them on??????????