View Single Post
Old 03-24-2010, 09:11 AM   #1
carwash
pimpin' IS easy
 
Join Date: Jan 2007
Location: Union, KY
Posts: 3,344
Send a message via AIM to carwash Send a message via Yahoo to carwash
I just have to share these... 2" - 47 spline

This stuff is just to sexy not to show off... this is the 2" 47spline cromo conversion from Ouverson for the 2.5 ton rockwell... 5 ton strength in a 2.5 housing, if i break these i apparently have bigger problems...

Now, just try and tell me that this **** ain't dead sexy...









I have a nice comparison shot i haven't pulled off the camera yet... add it tonight or tomorrow.

This is for the rear steer axle... here is the rest of the parts to make it all work, should roll it all together within a couple weeks. Steering valve and controller etc from Sean at POS, and ram from surplus center. Doing this on the cheap... ha.







The axle had the very undesirable Rzeppa (pronounced cheppa for some reason) shafts, and wouldn't have lasted 20 minutes of trail pounding. so they go wrapped up and will be trail spares. Not sure i will even trust them to get me back to camp.



__________________


carwash is offline   Reply With Quote