Quote:
Originally Posted by carwash
...these come in 1"x12tpi and 1.25x14tpi, use these for threaded...
|
Close, but I think you got them backwards on the thread pitch...
1"x14tpi and 1.25"x12tpi from polyperformance... unless they are wrong...
I was gonna do the left and right threaded shanks (per link), but I think the one ended adjustable sounds easier and slightly cheaper... hrmmmm...
I guess I'll get REALLY good at Hi-Lifting/winching the weight off the link to adjust it...
I just figured out that it would save about $200 to go with one non-adjustable... looking even better.
I'm not so sure about the adjustable truss idea... I like the fact that everything is welded into one (more or less) contiguous piece of metal... those adjustable bits would have to be BEEFY... I would say that they should be every bit as large as the threaded JJ ends... 1.25" on both sides... BEEF, serious BEEF.
Anyone else?