Quote:
Originally Posted by blazerbrad
Do you mean cut down the middle, as in turning the pipe into 2 long "C" shaped pieces?
FYI - I've seen some people try this with smaller tubing and it always curled up some (did not stay flat). Not sure if the schedule 40 would do that or not.
|
Yes I am looking to have 2 long "C" shaped channels. It should not curl up. I am assuming this is schedule 40. Its 4 1/2" OD, 4" ID and 1/4"Wall. I am making rock rails for the HUMMER.
I have a PM into NUTS to take him up on his offer but have not heard back yet.