C.O.R.E. FORUM - View Single Post

cmartin · 02-25-2014, 11:23 PM

Got the bracket for the orbital made up. It was harder than I thought it would be to fit it in there. It ended making the steering shaft a little closer to the header than I wanted but ended up good. If I would have angled it the orbital lines would have ran close to the belt.

The reason for the bracket. The unibody has an offset where the steering box was.

Test fit

All mounted up

Ran wire for the lengths of the hydro lines. Got them all mocked up.

May run this one in front of the upper bracket. But there is more room than it looks.

02-25-2014, 11:23 PM	#96
cmartin Join Date: Feb 2011 Location: miamisburg Posts: 191	Got the bracket for the orbital made up. It was harder than I thought it would be to fit it in there. It ended making the steering shaft a little closer to the header than I wanted but ended up good. If I would have angled it the orbital lines would have ran close to the belt. The reason for the bracket. The unibody has an offset where the steering box was. Test fit All mounted up Ran wire for the lengths of the hydro lines. Got them all mocked up. May run this one in front of the upper bracket. But there is more room than it looks.