Missing in certain RPM range.

gonejeepin · 02-09-2008, 10:23 PM

My 01 tj with the 4 cyl. has started to miss at about 1900-2100 rpm. It runs great other then that. This jeep had an deep water excursion last year. I replaced the TPS unit, plugs, wires, cap & rotor after that. When I get to around 1900 rpm it misses and if I am cruising at around 2000 it starts missing. I have no engine codes as of right now... Let my know what you think. Is there another senor that could be bad? Like the Map sensor or O2 sensor or something....? Also it always seems to idle lower than my other Jeep is there a throttle ajustment on it? :confused:

94Dodge Truggy · 02-09-2008, 11:19 PM

It is not the clutch slipping is it? Could be the coil? Not sure though. Inject it with propane!

MrShoeBoy · 02-10-2008, 04:43 PM

Does it miss under acceleration or when cruising? Does it happen at WOT? Or does it happen all the time?

AARON

gonejeepin · 02-10-2008, 06:04 PM

Quote:

Originally Posted by MrShoeBoy

Does it miss under acceleration or when cruising? Does it happen at WOT? Or does it happen all the time?

AARON

It misses on acceleration when it hit 1900-2000 rpm before or after that it accelerates fine. When cruising it runs fine below or above that range. As soon as the rpm drop to that range it starts missing? It only happens in that range with the engine hot or cold. At WOT it will hesitate at the same range? Thanks, Danny

gonejeepin · 02-10-2008, 06:12 PM

Quote:

Originally Posted by 94Dodge Truggy

It is not the clutch slipping is it? Could be the coil? Not sure though. Inject it with propane!

Someone else suggested the coil also. I will have to check that out. Did you sell the 94 Truggy? Can wait to see the new one. How does that propane injection work? Thanks, Danny

94Dodge Truggy · 02-10-2008, 10:14 PM

Propane is simple but what you have is fine and just needs some tlc.

MrShoeBoy · 02-14-2008, 01:51 AM

Its been my experiance that when a coil starts to go, it effects higher RPMs first, then hits the lower range. I would look at the MAP sensor. Ran into a similar issue with the motor in my XJ. Ended up replacing the MAP sensor and tweaked the connector and it ran fine.

AARON

gonejeepin · 02-17-2008, 10:26 AM

Quote:

Originally Posted by MrShoeBoy

Its been my experiance that when a coil starts to go, it effects higher RPMs first, then hits the lower range. I would look at the MAP sensor. Ran into a similar issue with the motor in my XJ. Ended up replacing the MAP sensor and tweaked the connector and it ran fine.

AARON

Would the Map sensor throw an error code? Or maybe not since is not missing all the time? Thanks, Danny

02-09-2008, 10:23 PM	#1
gonejeepin www.tjhardcore.com Join Date: Apr 2007 Location: Dayton, Oh Posts: 27	Missing in certain RPM range. My 01 tj with the 4 cyl. has started to miss at about 1900-2100 rpm. It runs great other then that. This jeep had an deep water excursion last year. I replaced the TPS unit, plugs, wires, cap & rotor after that. When I get to around 1900 rpm it misses and if I am cruising at around 2000 it starts missing. I have no engine codes as of right now... Let my know what you think. Is there another senor that could be bad? Like the Map sensor or O2 sensor or something....? Also it always seems to idle lower than my other Jeep is there a throttle ajustment on it? :confused:

02-10-2008, 04:43 PM	#3
MrShoeBoy Join Date: Dec 2007 Location: Cincinnati Posts: 120	Does it miss under acceleration or when cruising? Does it happen at WOT? Or does it happen all the time? AARON __________________ 91 MJ Under construction

02-14-2008, 01:51 AM	#7
MrShoeBoy Join Date: Dec 2007 Location: Cincinnati Posts: 120	Its been my experiance that when a coil starts to go, it effects higher RPMs first, then hits the lower range. I would look at the MAP sensor. Ran into a similar issue with the motor in my XJ. Ended up replacing the MAP sensor and tweaked the connector and it ran fine. AARON __________________ 91 MJ Under construction

02-09-2008, 11:19 PM	#2
94Dodge Truggy EX-Vice President Join Date: Jan 2007 Location: Fairfield, Ohio Posts: 3,048	It is not the clutch slipping is it? Could be the coil? Not sure though. Inject it with propane!

02-10-2008, 10:14 PM	#6
94Dodge Truggy EX-Vice President Join Date: Jan 2007 Location: Fairfield, Ohio Posts: 3,048	Propane is simple but what you have is fine and just needs some tlc.