how strong is a crysler 8.25

dan · 01-04-2011, 01:40 AM

here within the next month ill be upgrading my front axle in my xj to a d44 but my question is how strong is the 8.25 ill be running 33's and the most ill go up to is a 36 so will it hold up to it for moderate wheeling any input will be greatly appercaited

WrenchMonkey · 01-04-2011, 01:45 AM

My understanding is that the early 27 spline is okay, but the later 29 (which I think your 98 would have) is comparable to a D44. I'd trust it to run 36s.

I'm sure somebody will chime in to tell me I'm fulluvit. :)

Robert

dan · 01-04-2011, 03:01 AM

i have heard that its almost as strong as a d44 but wanted to know if it was worth up grading with alloy shafts and a locker

94Dodge Truggy · 01-04-2011, 07:43 AM

stronger than a tirdy5! I would run 36's with light wheeling in mind.

blazerbrad · 01-04-2011, 08:49 AM

I'm not familiar with them in off-roading applications, but I know they will not hold up under a completely stock V-8 powered Dakota or Durango under hard use on the pavement (if it was part time 2wd....full-time 4wd would hold up because the front was always taking some of the torque). Rarely had problems with the 9.25" rears but the 8.25" would fail predictably in a short period of time.

Granted, a lot of the failures seemed to revolve around the carrier and especially the trash-loc equipped ones so an upgraded carrier would likely make a difference.

On paper the 8.25" 29 spline is just slightly below the D44 in strength because of the slightly smaller ring gear and shafts (8.5" ring gear and 30-spline shafts)......but quite a bit stronger than a D35.

01-04-2011, 01:40 AM	#1
dan gotta love middletucky Join Date: Jan 2007 Location: Middletown Posts: 106	how strong is a crysler 8.25 here within the next month ill be upgrading my front axle in my xj to a d44 but my question is how strong is the 8.25 ill be running 33's and the most ill go up to is a 36 so will it hold up to it for moderate wheeling any input will be greatly appercaited __________________ 98 xj 4.5" lift

01-04-2011, 01:45 AM	#2
WrenchMonkey Mechanical Animal - CORE Member - - Moderator - Join Date: Feb 2008 Location: Beechmont Posts: 1,883	My understanding is that the early 27 spline is okay, but the later 29 (which I think your 98 would have) is comparable to a D44. I'd trust it to run 36s. I'm sure somebody will chime in to tell me I'm fulluvit. :) Robert __________________ DIRTY DEEDS, DONE DIRT CHEAP Whatever doesn't kill you makes you stranger

01-04-2011, 03:01 AM	#3
dan gotta love middletucky Join Date: Jan 2007 Location: Middletown Posts: 106	i have heard that its almost as strong as a d44 but wanted to know if it was worth up grading with alloy shafts and a locker __________________ 98 xj 4.5" lift

01-04-2011, 07:43 AM	#4
94Dodge Truggy EX-Vice President Join Date: Jan 2007 Location: Fairfield, Ohio Posts: 3,048	stronger than a tirdy5! I would run 36's with light wheeling in mind. __________________

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

01-04-2011, 08:49 AM	#5
blazerbrad - CORE Member - Join Date: Feb 2007 Posts: 831 Images: 6	I'm not familiar with them in off-roading applications, but I know they will not hold up under a completely stock V-8 powered Dakota or Durango under hard use on the pavement (if it was part time 2wd....full-time 4wd would hold up because the front was always taking some of the torque). Rarely had problems with the 9.25" rears but the 8.25" would fail predictably in a short period of time. Granted, a lot of the failures seemed to revolve around the carrier and especially the trash-loc equipped ones so an upgraded carrier would likely make a difference. On paper the 8.25" 29 spline is just slightly below the D44 in strength because of the slightly smaller ring gear and shafts (8.5" ring gear and 30-spline shafts)......but quite a bit stronger than a D35.