Shop Press

MrShoeBoy · 08-22-2008, 03:09 PM

I have been watching craigs list and saw that press, but its about 2 hours north of here and it would be cheaper to buy one new than drive up there and get it!

I think I am just going to get the HF 20T press since I got a 15% off coupon from my neighbor

That post about the arbor plates is SCARY! We had thoes same plates at the rock shop and my buddy cracked one pressing out a seized bushing. Scared the **** out of us enough that we threw them in the scrap pile and got some cold rolled bar. When the bar bends, its time to stop

Thanks for the replies. Now all I need is a spanner wrench for a 9" and I will be good to go for my gear install

AARON

08-22-2008, 03:09 PM	#10
MrShoeBoy Join Date: Dec 2007 Location: Cincinnati Posts: 120	I have been watching craigs list and saw that press, but its about 2 hours north of here and it would be cheaper to buy one new than drive up there and get it! I think I am just going to get the HF 20T press since I got a 15% off coupon from my neighbor That post about the arbor plates is SCARY! We had thoes same plates at the rock shop and my buddy cracked one pressing out a seized bushing. Scared the **** out of us enough that we threw them in the scrap pile and got some cold rolled bar. When the bar bends, its time to stop Thanks for the replies. Now all I need is a spanner wrench for a 9" and I will be good to go for my gear install AARON __________________ 91 MJ Under construction

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode