anyone know a good press shop

f4isvt · 05-31-2011, 07:52 PM

I upgraded to rear disc and chromoly axles and have been dragging my feet forever to finally finish it. I ordered new bearing pockets which I havent got yet, new wheel bearings and retainers for the axles now I just need the bearings pressed into the pockets, pockets pressed on the axle, and the retainer pressed on. The few machine shops I called in dayton want what I think is ridiculous money to do it. Most of them tell me they don't even have the adaptors to do it and would have to charge to either make or buy an adaptor. Any suggestions?

05-31-2011, 07:52 PM	#1
f4isvt Join Date: Jul 2009 Location: Beavercreek/Dayton Posts: 47	anyone know a good press shop I upgraded to rear disc and chromoly axles and have been dragging my feet forever to finally finish it. I ordered new bearing pockets which I havent got yet, new wheel bearings and retainers for the axles now I just need the bearings pressed into the pockets, pockets pressed on the axle, and the retainer pressed on. The few machine shops I called in dayton want what I think is ridiculous money to do it. Most of them tell me they don't even have the adaptors to do it and would have to charge to either make or buy an adaptor. Any suggestions? __________________ 1989 ext cab yota 22re bored .20 over trd cam, trd headers, Marlin crawler front bumper w/stinger, Marlin crawler roll cage, trailgear rear bumper, trailgear rock sliders, richmond 5.29's, and lockright rear, 33 nokian mt's. 10k winch. Rear disc conversion. Chromoly rear axle shafts. Bombproof motor mounts and transfer case mount. Whole lot of rust and scratches.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode