chevy d44 ball joint question???

nshefbuch · 07-17-2011, 06:05 PM

i'm installing new (everything) and on the upper ball joint, the threaded sleeve that goes into the "C" of the axle, how far do i thread this? flush on top or bottom? ball joints say they are a "zero degree" camber - from napa

also, when you get front end alignment do the shops adjust this sleeve?

thanks for any help

- ryan

07-17-2011, 06:05 PM	#1
nshefbuch Join Date: Jul 2008 Location: piqua, ohio Posts: 76	chevy d44 ball joint question??? i'm installing new (everything) and on the upper ball joint, the threaded sleeve that goes into the "C" of the axle, how far do i thread this? flush on top or bottom? ball joints say they are a "zero degree" camber - from napa also, when you get front end alignment do the shops adjust this sleeve? thanks for any help - ryan

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode