Machine Shop Needed

RuffedUpXJ · 07-27-2010, 04:28 PM

I do maintence on my cousins' lawn mowers for their business and they recently let a walk-behind run low on oil. Its a Toro I believe and with a Kawaski engine. I was wondering if anyone knew of a machine around to rebore so I can put a larger piston it and hopefully get them going versus paying $1600 for a new crate engine from their dealer.

I would assume this is reasonable since its a 17 hp motor and I can imagine that they have a series of motors that use the same block/piston setup and I would believe they have over sized pistons for this matter.

Anyone know a machine shop in the hamilton/Fairfield/Mason aera that would bore it out for me?

07-27-2010, 04:28 PM	#1
RuffedUpXJ On XJ 2 Now Join Date: Feb 2007 Location: Fairfield Twp. Posts: 314	Machine Shop Needed I do maintence on my cousins' lawn mowers for their business and they recently let a walk-behind run low on oil. Its a Toro I believe and with a Kawaski engine. I was wondering if anyone knew of a machine around to rebore so I can put a larger piston it and hopefully get them going versus paying $1600 for a new crate engine from their dealer. I would assume this is reasonable since its a 17 hp motor and I can imagine that they have a series of motors that use the same block/piston setup and I would believe they have over sized pistons for this matter. Anyone know a machine shop in the hamilton/Fairfield/Mason aera that would bore it out for me? __________________ 88 XJ - 5" lift - 35" BFG's - Bumpers - Rock Rails - Homebrewed OBA - Roof Rack - Tube Doors - Trimmed - Dented 87 XJ - D44 - Disco D30 - 235's - 231TC - Stock for now