Suspension link questions

JeffK5 · 03-16-2007, 10:17 PM

Are you still talking about putting 1.25/12 in a 1.75 o.d tube? Because it's no different if you thread the tube direct or bore for a pre-machined tube adapter?

That's why I like the 2.0x.5, just bore the tube out to minor dia. of the 1.25/12 and chase a thread or run a tap in.

To be honest both .250 and .375 wall would be more than strong enough IMO.

Let me know I might be able to set you up with a slab and tap job!;)

03-16-2007, 10:17 PM	#5
JeffK5 Tiny Member Join Date: Jan 2007 Location: Colerain Posts: 798	Are you still talking about putting 1.25/12 in a 1.75 o.d tube? Because it's no different if you thread the tube direct or bore for a pre-machined tube adapter? That's why I like the 2.0x.5, just bore the tube out to minor dia. of the 1.25/12 and chase a thread or run a tap in. To be honest both .250 and .375 wall would be more than strong enough IMO. Let me know I might be able to set you up with a slab and tap job!;) Last edited by JeffK5; 03-16-2007 at 10:18 PM. Reason: I can't spell

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode