Rod End Question...

biggin69 · 04-14-2010, 07:06 PM

Bad News!!! I placed an order with Currie today and they called me and said that all Johnny Joints are on backorder until the end of May!!!

Whos joints should I buy now?

bgwyllys61 · 04-14-2010, 11:00 PM

Ive been running the Ballistic joints for about a year, on my upper control arm, the only issue ive had is them loosening up a bit, but, you just tighten the preload back down and forget about it, just make sure to keep them greased up

bgwyllys61 · 04-14-2010, 11:05 PM

if you need them to be adjustable, try these http://www.ballisticfabrication.com/...nt_p_1636.html

ive been running these with no problems, other than a tad bit of slop that i took out when i tightened them back down, basically the same joint as above, just no threaded stud
http://www.ballisticfabrication.com/...nt_p_1226.html

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

04-14-2010, 07:06 PM	#1
biggin69 Really??? Join Date: Sep 2009 Location: Cincy Posts: 678	Bad News!!! I placed an order with Currie today and they called me and said that all Johnny Joints are on backorder until the end of May!!! Whos joints should I buy now?

04-14-2010, 11:00 PM	#2
bgwyllys61 fullwidthxj Join Date: Feb 2008 Location: lex Posts: 15	Ive been running the Ballistic joints for about a year, on my upper control arm, the only issue ive had is them loosening up a bit, but, you just tighten the preload back down and forget about it, just make sure to keep them greased up

04-14-2010, 11:05 PM	#3
bgwyllys61 fullwidthxj Join Date: Feb 2008 Location: lex Posts: 15	if you need them to be adjustable, try these http://www.ballisticfabrication.com/...nt_p_1636.html ive been running these with no problems, other than a tad bit of slop that i took out when i tightened them back down, basically the same joint as above, just no threaded stud http://www.ballisticfabrication.com/...nt_p_1226.html