Shackle Mount relocation

RuffedUpXJ · 01-26-2008, 12:13 PM

Since I have noticed a lot of us XJ guys have horrible shackle angles I thought I would look into building a mount the relocates the shackle forward and lower to help with the angle. All of the steel will be 1/4" thick. And the sleeve will be basically that exact sleeve a shackle uses so it can easily bolt into the stock location.Also I wanted to make a part that was almost entirely bolt in. So here are a couple of pics from ProE. Have any of you tried this or looked into it farther than this?

01-26-2008, 12:13 PM	#1
RuffedUpXJ On XJ 2 Now Join Date: Feb 2007 Location: Fairfield Twp. Posts: 314	Shackle Mount relocation Since I have noticed a lot of us XJ guys have horrible shackle angles I thought I would look into building a mount the relocates the shackle forward and lower to help with the angle. All of the steel will be 1/4" thick. And the sleeve will be basically that exact sleeve a shackle uses so it can easily bolt into the stock location.Also I wanted to make a part that was almost entirely bolt in. So here are a couple of pics from ProE. Have any of you tried this or looked into it farther than this? __________________ 88 XJ - 5" lift - 35" BFG's - Bumpers - Rock Rails - Homebrewed OBA - Roof Rack - Tube Doors - Trimmed - Dented 87 XJ - D44 - Disco D30 - 235's - 231TC - Stock for now

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode