![]() |
#1 |
Join Date: Aug 2010
Location: Colerain
Posts: 10
|
Sye install
Bought a sye for my wrangler.
How difficult is it to install? Can I do it with TC still in jeep? Never messed with a transfer case before. Thanks |
![]() |
![]() |
![]() |
#2 | |
SeƱor Monkey
Join Date: May 2012
Location: Georgetown, Ohio
Posts: 185
|
Quote:
You will need "snap ring pliers" and "retaining clip" pliers. (They are not the same tool.) Here's a link to a great video of how to do the project. http://www.youtube.com/watch?v=jTOpd_pTb3g Andy |
|
![]() |
![]() |
![]() |
#3 |
Join Date: Aug 2010
Location: Colerain
Posts: 10
|
Thanks for the info!
I am going to tackle this later this week. Video makes it look pretty simple. |
![]() |
![]() |
![]() |
#4 |
Join Date: Feb 2011
Location: Independence, KY
Posts: 40
|
I did one on my XJ 2 years ago. not too difficult. much easier to pull the t case than to do it in the jeep. Follow the instructions that come with it, and if those get ya confused, use good to find a few write ups. plenty of them out there, its how i got through it.
__________________
Project ZJ (Zombie Jeep)- 1995 Jeep ZJ undergoing axle swap, 4-link, and becoming a firewall buggy. |
![]() |
![]() |
![]() |
#5 |
Mechanical Animal
- CORE Member -
- Moderator - Join Date: Feb 2008
Location: Beechmont
Posts: 1,883
|
I did mine in the rig, just because the shift linkage looked hard to get to, to drop it.
Either way, wasn't bad. Good luck! Robert
__________________
DIRTY DEEDS, DONE DIRT CHEAP
Whatever doesn't kill you makes you stranger |
![]() |
![]() |
![]() |
|
|