So the time has come to link the front of my Rig, I have had alot of broken springs over alot of years and with the terrain that I tackle my body had been taken a beating along with my Rig
Announcement
Collapse
No announcement yet.
Toyota Front 3 link
Collapse
X
-
No need for a Winch...You just have to make it !!
-
There are alot of different places to shop for weld on tabs, Heims, and brackets of all sorts, I had to figure out if I was gonna custom make most of my link mounts or go with some good quality mounts that I can customize to make work for my needs, this turned out to be the best decision.
I did have to customize some of the brackets to work for my project, but let's face it, alot of rigs are PMC..Pretty much custom. I could not beat the price of the Heims for this price for as much as I shopped around. It made pretty quick, nice work out of most of this setupNo need for a Winch...You just have to make it !!
Comment
-
After alot of investigation and horror stories I would advise beefing up the Frame where the panhard mount will be located, You cannot overdue this !! This is a major common fail on a front 3 link, I used 1/4 plate over the frame on the side and in the bottom and plug welded, make sure you spread it way beyond the stress point.No need for a Winch...You just have to make it !!
Comment
-
Measure so many times that you will be sick of measurements when you are tacking things in place, I found a few mistakes and had to remove and remeasure again.
Don't get in a hurry in this or you will regret it, there are alot of angles and things that will be very close while flexing and turning when you still have steering and you haven't changed over to full Hydraulic.No need for a Winch...You just have to make it !!
Comment
-
Thanks for answering for me Mark, yes things are close but ok, will hopefully have truck on RTI ramp tomorrow to max out suspension to look things over, Mark, Kevin, and I played with it last weekend on the lift and it appears everything will be ok but prefer to twist everything up as much as possible. With suspension fully compressed steering is bout 1/8 of a inch away from the oil pan and my top link bar is bout 1/2 away from clutch slave cylinder. Will post up more pics and info as I can.No need for a Winch...You just have to make it !!
Comment
-
16 inch ORI's was decided as my choice after alot and i mean alot of research on what to run for my wheeling style and terrain that we tackle, they are very easy to dial in, require no bumps tops, limit straps, don't unload so you don't need a suck down winch and are very predictable and by a turn of a screw with a smile you can set it how you like it. So far I haven't adjusted anything and it rides better than any vehicle that I own.No need for a Winch...You just have to make it !!
Comment
-
Kevin and Mark really helped me out big time on this project, without them I would NOT be ready for Harlan at the end of May, we worked on this rig all day long on Sunday, Mark and Kevin took it upon themselves to finish up on Monday mostly without me. Man its hard to find good hard working wheeling buddy's these days, I can't thank them enoughNo need for a Winch...You just have to make it !!
Comment
Comment