wheel adapters?

sarge · 09-21-2007, 05:03 PM

ran them on all four corners of my camaro to fit the ZR1 rims , all of them were 2" . I'm going to run them on the Jeep as soon as I find a good deal on a set.\
What axle are you looking at putting under your XJ that's 5 on 5.5 ?

eighty3bronco · 09-21-2007, 08:51 PM

most likely an 8.8

scarface · 09-21-2007, 09:40 PM

Quote:

Originally Posted by eighty3bronco

most likely an 8.8

dat be correct

sarge · 09-21-2007, 11:13 PM

ok ! most people use the 8.8 out of an explorer for a jeep swap ! 5 on 4.5 and 31 spline shafts.

scarface · 09-22-2007, 12:36 AM

Yeah this one came from a bronco so it threw me off a little. but it is full width or darn close

sarge · 09-22-2007, 01:38 AM

are you going to run spacers on the front ? All of the coversion adapters that I have seen give you at least 1.25" width , these on a full width in the rear are going to be much wider then the D30 in the front . 3"-4" spacers on a D30 is going to put a heck of a lot of stress on your ball joints and unit bearings.

JeffK5 · 09-22-2007, 03:00 PM

Think .. scrub radius!

09-21-2007, 08:51 PM	#2
eighty3bronco anywhere but there Join Date: Jan 2007 Location: Blanchester, Oh Posts: 174	most likely an 8.8 __________________

09-22-2007, 12:36 AM	#5
scarface I beat anorexia! Join Date: Feb 2007 Location: Fairfield Posts: 175	Yeah this one came from a bronco so it threw me off a little. but it is full width or darn close __________________ I believe this will be our finest hour

09-21-2007, 05:03 PM	#1
sarge Pure Bacon Join Date: Jan 2007 Location: Trenton, Oh Posts: 1,098	ran them on all four corners of my camaro to fit the ZR1 rims , all of them were 2" . I'm going to run them on the Jeep as soon as I find a good deal on a set.\ What axle are you looking at putting under your XJ that's 5 on 5.5 ?

09-21-2007, 11:13 PM	#4
sarge Pure Bacon Join Date: Jan 2007 Location: Trenton, Oh Posts: 1,098	ok ! most people use the 8.8 out of an explorer for a jeep swap ! 5 on 4.5 and 31 spline shafts.

09-22-2007, 01:38 AM	#6
sarge Pure Bacon Join Date: Jan 2007 Location: Trenton, Oh Posts: 1,098	are you going to run spacers on the front ? All of the coversion adapters that I have seen give you at least 1.25" width , these on a full width in the rear are going to be much wider then the D30 in the front . 3"-4" spacers on a D30 is going to put a heck of a lot of stress on your ball joints and unit bearings.

09-22-2007, 03:00 PM	#7
JeffK5 Tiny Member Join Date: Jan 2007 Location: Colerain Posts: 798	Think .. scrub radius!