:mad: nissan pickup with the 2.4 4cyl when driving it once it gets to 3500 rpm it completly falls on its face and wont pick up untill about 2700 rpm, wht gives? somebody chime in :confused:
Announcement
Collapse
No announcement yet.
3500 RPM, falls on its face
Collapse
X
-
i had a 88 mazda p/u that did the same thing... Took me forever to figure it out... The filter was almost on top of the tank... Fuel filter fixed it...
good luck
Chris
sigpicchris hodges
96 fzj80 3x locked, 4"lift, 37s, homebrew sliders and bumpers,a work in progress
71 fj55, SOA, locked...The jungle bus... retired
Comment
-
sometimes with obdI you can get in your book and there will be 2 pins you can cross on the plug with a paper clip or jumper wire and it will make your service light flash a certain pattern when you turn they key on and that pattern will be in defined in your book (haynes)...hope this helps..S10 with a few air shocks..
Comment
-
Originally posted by bgwyllys61 View Postcat, converter? had a ford truck do this same thing, ran great except for a certain rpm, it wouldnt do anything, but if you got past it, or before the rpms it ran fine
Originally posted by humpy View Postsometimes with obdI you can get in your book and there will be 2 pins you can cross on the plug with a paper clip or jumper wire and it will make your service light flash a certain pattern when you turn they key on and that pattern will be in defined in your book (haynes)...hope this helps..
Originally posted by gothodgie View Postdamn.... good luck...2013 RZR S
Comment
-
Originally posted by bgwyllys61 View Postcat, converter? had a ford truck do this same thing, ran great except for a certain rpm, it wouldnt do anything, but if you got past it, or before the rpms it ran finebrad
5.0L | 435 | 203 | 300 | 4.10 | 39.5
Buildup BACK underway...
sigpic
Comment
-
unbolted exhaust before cat... and.... still same thing. :(
also bought a new dist. cap and rotor button and that didnt help either.
noticed that the dist. looked retarded.. ;) so took it loose and forked around with it a bit. got a little better but went up to about 4100 rpm b4 it starts its s41t
**Also, if you mash the skinny pedal from idle it stumbles over itself, clears up about 1300 then starts to its normal bull-snot at 3800 :mad:
im going to buy a chiltons i guess, insted of throwing parts at it2013 RZR S
Comment
Comment